An article written by John LeVasseur called "A Treatise on DIY CO2 Systems for Freshwater-Planted Aquaria" describes a cheap and efficient DIY CO2 system, as well as different injection methods. This is the most widely used and best DIY system that exists in my opinion. I've provided a link to his ingenious designs and research here: http://www.qsl.net/w2wdx/aquaria/diyco2.html
Be warned, he goes incredibly in depth about each and every detail in the system, so if you don't have the best attention span, this may not be an article for you.
Based off LeVasseurs design, I built my own CO2 generator- with one modification. Most DIY CO2 generators work off sugar water and anaerobic yeast, meaning the yeast has no oxygen to produce energy with. I altered the design and added an air pump, giving the yeast O2 causing it to create more CO2, energy, and less alcohol byproduct.
It's rough on the eyes, but it has created an ungodly amount of CO2 for my plants. Due to the CO2, my pH dropped from 7.5 to 6.5 overnight, meaning if nothing went wrong I have approx 200-300ppm of CO2 in the tank, depending on my water hardness. Remember, 10-15ppm is more than optimal.
That being said, I do believe something has gone awry. I left my design running all night long (and had nightmares about something clogging and having a buildup of pressure, causing the entire thing to explode) and when I woke in the morning, something was wrong with my tank.
...and this is the shot of my tank this morning.
Obviously, the water had become quite foggy. Looking online, it seems this is a common problem with aerobic yeast CO2 generators. People say that it's either a bacteria bloom or yeast in the water. Both are likely, as if sugar got into the water it would certainly cause a bacteria bloom, and if yeast got into the water it could explode as well. I believe a contaminant made it's way into the water, and I have a solution for solving this problem in my next design of this CO2 generator.
The more I got to looking at the tank, the more I began to think yeast made it's way into the water. I found stringy dough like things in my tank. It's on the plants, hanging from the filter/air pump... It's all over.
I know how to solve this in my next CO2 project however. The original design calls for a second bottle to keep liquid out of your tank. In my design, it's the smaller bottle on the left. It exists in case any liquids get sucked through the piping- I would rather have them end up here than in the tank. Well, this works just fine for anaerobic yeast designs, but I suspect that's not the case for aerobic yeast designs. In aerobic yeast, the yeast creates about 16 times the amount of energy that anaerobic yeast does. I am wondering if this causes the yeast to breed rapidly and or create spores. If it can create airborne spores of yeast, the yeast spores can fly through the tubes and the second bottle and land in the tank. That would be able to do it I think. However, even if the yeast isn't creating some kind of spore, it must have an airborne form that got it into the tank.
My solution to this challenge is to add water to the second bottle to trap most yeast, as well as add some kind of cotton filter to the tubing that leads into the tank.
I cleaned up the water by doing a 50% water change (I lost so much CO2 I'm sure) and netting out what gunk I could. Hopefully this problem can be overcome easily, and hopefully this gunk is just an ascetic problem.
Well, until next time I suggest you look up the DIY CO2 generator with the link I provided. In case you missed it, here it is again: http://www.qsl.net/w2wdx/aquaria/diyco2.html
The normal unmodified CO2 generator works like a charm and I highly endorse it. I hope you use this information to somehow better your own tanks. Cheers!





No comments:
Post a Comment