Saturday, February 15, 2014

Tank Update: 2/14/14

Sorry guys, this one is rather late! It was Valentines day, so I was out on a date and exhausted afterwards. So, there's my excuse.

Now, about the tanks. Well first off I tried my old test kit and did a water test. It's showing the big tank has about .75ppm of ammonia, but still no nitrites. That's impossible, as I'd the ammonia was holding steady at 1 or lowering like it says, then ammonia would be converted to nitrites. It's just not possible. So if nothing else, my nitrite test is absolute rubbish. The little tank is showing high levels of ammonia, which is fine because there are no fish in there. In fact , that may be better for the plants.

Back to the big tank now. I have noticed little green specks on the glass of the tank. They appeared after some of my new algae pellets were introduced, but they were so minor I didn't pay much attention to it. Now the front glass has the bottom left corner covered in little dots. They are most definitely algae, and after doing some research, it shouldn't be hard to fix. I'm just surprised the pleco didn't jump on it before it became an issue.

Also, future thoughts and plans... I'm going to get quite a few livebearing  fish like guppies and platys in my big tank. Now, this would create a large quantity of baby fish called fries, as every 3 weeks or so the fish will give birth. To deal with this, I think I'll turn the 5 gallon into a nursery. I'll allow my little sister to still have the tank, but when a fish is going to give birth, I'll put them in a hang on the side box. Essenicially, I'd have a clear box that hangs on the tank and sits in the water. Then I'd have the pregnant fish in that box, and as she gives birth, the babies can easily be dumped into the nursery tank. This glass box will also have vertical slits in the sides of it to allow water to flow through the box, allowing oxidation. Just as well, I may make the slits big enough for fries to escape into the tank while the mother is still unable to. There are small design issues I would like to work out, but the primary design is finished. I think I'll have to make it out of acrylic to get what I want done, but that would be fine. Also, I believe that these exist in pet stores as I always see something similar when places like petsmart take fish out of a tank. It's worth looking into before I build my own. 

On the same note of the nursery tank, I will need to change my filtration. To keep fries from getting killed, I'll need a sponge filter, which is easy and inexpensive to build. I will make a post showing how to build one, as well as give a link to "The King of DIY" who made a video showing how to build a similar design.

Well I believe that is all for this update. Until next time!

No comments:

Post a Comment